Olivetti ECR 7700LD Guide de l'utilisateur télécharger pdf (Page 11)

ENGLISH

Operator and Customer Displays

Your cash register is equipped with two 10-digit

alphanumeric Vacuum Fluorescent Displays (VFD). With

reference to figure 6, the display is read from left to right as

follows:

C1...C8 (1) - With the Clerk System active,

indicates the clerk number entered

before working in the REG or JRNL

mode, or when

is pressed.

Department (2) - A set of digits indicating the

department key pressed for each

entry.

Repeat/Multiply (3) - A number displayed when

repeating or multiplying items to

indicate the number of items entered

at one price.

Amount (4) - Indicates entry amounts and

sales totals.

Special Symbol Indicators

Special symbols appear at the far left-hand side of the

displays during cash register operation:

C (Change) Indicates that the displayed amount is the

change due to the customer.

E (Error) Indicates when an error is made during

operation or when programming the cash

operator.

ST (Sub-total)

Indicates that the amount shown is the

subtotal of a transaction, including sales tax

if applicable.

- (Minus) Displays a negative entry. Also displays if

subtotal or cash tendered total is a negative

number due to a return or refund.

_ (Line) Indicates, from left-to-right on the bottom of

the display, the calculator mode, receipt off

mode, training mode and an electronic

journal nearly full condition (less than 700

transaction lines available).

Displayed when is pressed to indicate

that the amount is displayed in foreign

currency.

CA (Cash) Indicates a sales transaction paid by cash.

Ch (Check) Indicates a sales transaction paid by check.

Cr (Charge) Indicates a sales transaction paid by credit

card.

These symbols clear automatically when you start the next

entry or press

Error Conditions

Error Codes

The following error codes can be displayed:

E1 Operation error

E2 Sales amount exceeded

E3 Zero-price entry error

E4 Incorrect full-void entry

E5 Clerk number and password requested

E6 Manager password requested

Clearing an Error

Press to clear an error. The tone ends, the displays

clear and the keypad unlocks, allowing you to continue

with the transaction or restart the program.

If an error condition cannot be cleared by pressing ,

reset the cash register by performing one of the cash

Cash Register Reset Operations

If the cash register does not function, for example while

programming and the error signal cannot be stopped by

pressing , reset the cash register.

There are four reset operations; be very careful when

choosing the one to perform since you could unnecessarily

cancel report data and cash register programming data.

Partial Reset

A Partial Reset operation just clears the cash register's

working memory.

1. Turn the control key to the OFF position.

2. Press

for about 2 seconds and then press

If the cash register still remains in an error condition,

proceed with the Full Reset - Reports operation.

Full Reset Reports

A Full Reset - Reports operation erases the cash register's

working memory, and all totals and counters (all report

data).

1. Turn the control key to the OFF position.

2. Press

for about 2 seconds and then press

If the cash register still remains in an error condition,

proceed with the Full Reset - New Language Entry Excluded

operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Olivetti ECR 7700LD Guide de l'utilisateur Page 11

Commentaires sur ces manuels